SCOTT SBX 10 SUBWOOFER Instruction Manual download pdf (Page 3)

GB- 2

CONTENT

PRECAUTIONS 1

CONTENT 2

BOX CONTENT 2

LOCATION OF CONTROLS 2

POWER SUPPLY 2

BASIC OPERATION 2

MAINTENANCE 3

TROUBLESHOOTING GUIDE 3

TECHNICAL SPECIFICATIONS 3

BOX CONTENTS

1. Unit

2. Pin for pairing

3. Instruction manual

LOCATION OF CONTROLS

RF 2.4 GHz wireless

subwoofer

1. Bass reflex tube

2. Standby/Power LEDs

(2x)

3. Speaker

4. Bass volume control

5. PAIR button

6. Crossover frequency

switch

7. PHASE switch

8. POWER ON/OFF

switch

9. AC cord

POWER SUPPLY

Connect the AC power cord to the mains with AC 100-240V ~ 50/60Hz power

source.

BASIC OPERATION

PAIRING

Pairing is to ensure your subwoofer can receive RF transmission correctly from

the docking station.

1. You have to reset the pairing first: when the docking station is in standby mode,

use the pin (supplied) to press and hold the PAIR button of the docking

station for more than 10 seconds until the source LEDS at the top of the

docking station flash for few seconds.

2. Press the PAIR button on the docking station then the PAIR button of the

other modules within one minute. All the standby LEDs will blink rapidly until

the pairing is successful in about one minute and the source LEDS at the top

of the docking station will flash for few seconds. Then the station goes into

standby mode.

Refer to the iDXS 10L or iXSW 50 manual for more information about pairing.

1 2 3 4

Comments to this Manuals

No comments

SCOTT SBX 10 SUBWOOFER Instruction Manual Page 3

Comments to this Manuals